Premade Fiber Optic Cable: Factory Terminated vs Field Work

Premade Fiber Optic Cable: Factory Terminated vs Field Work

A premade fiber optic cable arrives connectorized and tested at the factory. What that buys on schedule and loss — and the two places field splicing still wins.

A premade fiber optic cable is a cable plant section that leaves the factory with connectors installed and IL/RL tested per fiber. Against field termination it trades one thing for another: you pay for factory precision and shipping care, and you save crew hours, consumables and the variance of on-site polish quality. The decision is per route, not per project.

Where factory-terminated wins, where field wins

FactorPremade (factory)Field termination
SchedulePull, clean, plug — hours per runSplice/polish per fiber, days per room
Loss consistency≤0.3 dB typical / ≤0.5 dB max per end, testedCrew-dependent; verify every fiber
Route accuracyNeeds final measurements firstTolerates survey error
Long hauls, many splicesShipping a 3 km terminated reel is impracticalPigtail + fusion splice per closure
RepairsSwap the assemblyRe-terminate in place

Ordering checklist for premade runs

  • Freeze the route first. Factory lengths are exact; measure the installed pathway, add slack at both ends, then order.
  • Specify per end. Connector, polish and — for duplex — A/B polarity at each end, as with any single mode cord order.
  • Plan the pull. Terminated ends cannot pass small ducts; agree pulling eyes, drum handling and end protection before dispatch.
  • Accept on data. The factory test sheet travels with the reel; spot-check a sample on arrival and log the rest.

Key specifications at a glance

ParameterTypical value
Cable typesTight-buffered indoor, distribution, or outdoor loose tube
Fiber counts2–144 cores typical, factory-terminated
Insertion loss≤0.3 dB typical / ≤0.5 dB max per mated end (1310/1550 nm)
Return lossUPC ≥50 dB / APC ≥60 dB (typical, single mode)
Test recordPer-fiber IL/RL sheet shipped with each assembly
MOQPer assembly, factory-cut lengths
Lead time7–15 working days after deposit
Payment30% T/T deposit, balance before shipment
Warranty12 months from shipment date

Loss values are typical acceptance references; each assembly ships with its own tested record.

Buyer FAQ

Is premade always more expensive?

Per meter yes; per link often no. Crew hours, polishing consumables and rework usually close the gap on multi-fiber indoor routes.

Can outdoor cable arrive factory-terminated?

Yes for access-scale runs — outdoor-rated assemblies with pulling eyes and sealed ends are common; long-haul routes stay spliced.

What happens if the route changes after ordering?

Cut ends and splice on pigtails, or order a corrected length. That is why the route measurement freeze comes first.

Karar aracı

Bu güzergah için hazır mı saha mı?

Sonlandırma kararını seçin — yanıt, bu sayfadaki fabrika-saha kurallarını yeniden ifade eder.

Çözüm fiyat teklifi isteyin

Kurulum senaryonuzu, gerekli konnektör tiplerini, fiber sayılarını ve hedef miktarları tanımlayın. Girdileriniz ne kadar spesifik olursa mühendislerimiz uygun ürünleri ve üretim/teslim süresini o kadar hızlı teyit edebilir.

Ürün Talebi
◆
Ürün Talebi
Premade Fiber Optic Cable: Factory Terminated vs Field Work (premade-fiber-optic-cable)